Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
04-07-2004, 01:13 PM
|
#1 |
|
Registered Member
Join Date: Oct 2003
Location: Farmers Branch, Tx
Posts: 46
|
Has anyone installed a g-load bar?
I will probally be pulling my engine in the coming weeks and while it's out and being machined I will be cleaning and detailing the engine bay, repairing a bit o' rust I found and such stuff. During this time while the engine is out, I am considering installing a g-load bar. I see that HPM makes two different types, a 2pt and a 4pt. Any of you have one? It seems like a good idea, what are ya'll's thoughts on this?
I am also considering sub-fram connectors and a strut tower brace. It's a 1979 5.0 Mustang Hatchback. |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| CAI Installed Whew!?! | mustardjohn | Small Ponies | 0 | 11-08-2003 05:32 PM |
| Had 4.10's installed....car tops out at 99mph??!! | wantapony2001 | Modular Madness | 10 | 08-04-2003 02:31 PM |
| Eibach Springs Installed | COUSIN ROB | Modular Madness | 0 | 05-13-2003 09:17 AM |
| Getting Novi 1000 installed Wed. | Chris_H | Windsor Power | 3 | 12-31-2001 07:22 PM |
| Holley ignition, coil, and distributor installed..car won't start. Any ideas? | chadtn2 | Windsor Power | 5 | 08-13-2001 01:13 AM |