Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
09-08-2005, 09:07 AM
|
#1 |
|
Registered Member
Join Date: Aug 2005
Location: woburn
Posts: 16
|
67' rear end question
hi,
i am building up a 67' coupe, that came stock with an inline six. i will be done sometime soon with the build up of a 351w engine for it, im guess top hp will be about 370 at the very most. i will be using a tremec tko500. i was wondering if an 8.8" posi rear end out of a newer gt (foxbody) would be ok? also would i be better off switching the mounting components on the axle to accept leaf springs or fabricating a set up for rear coil springs? thanks for any help, carl |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| What kind of rear end do I have? | Stang_ROTY | Windsor Power | 3 | 01-29-2005 02:46 PM |
| rear end question | whitepony91 | Windsor Power | 1 | 03-25-2003 05:00 PM |
| Rear Brake Line Removal | Kisner | Classic Mustangs | 2 | 03-13-2002 12:31 PM |
| Rear end identification question | jerrys84 | Windsor Power | 3 | 02-26-2002 03:41 PM |
| question on the 7.5 rear | jays306LX | Windsor Power | 5 | 06-09-2001 04:03 PM |