Linear Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
09-14-2005, 09:25 PM
|
#1 |
|
87prjctpony
Join Date: Aug 2005
Location: seaside ca
Posts: 57
|
Front Suspension Sqeeks???
My 87's Front Suspension On The Drivers Side Makes A Squeeking Noise When I Turn Left, I Checked Where Its Coming From And Its Where There Is A Boot That Is Connected Next To The Tire!! I Remember When My Dad Use To Grease Up His Car But I Cant Find The Plug Under My Car To Do It!! Could That Be It???
__________________
i have a 87 5.0 gt with mac shorty headers, off-road h-pipe, mac mufflers, transgo shift kit, msd blaster coil, and 3.73 gears. o yeah aod tranny. |
|
|
|
09-15-2005, 01:51 AM
|
#2 |
|
Rat Killer
Join Date: Aug 2002
Location: Cold ass Ohio
Posts: 1,143
|
Re: Front Suspension Sqeeks???
Prolly an outer tie rod end. MAKE SURE it's not a strut mount before you change tie rods. That whole strut has to pivot in there, and I've seen alot of times where guys have changed tie rod ends, and that ain't the problem.
__________________
d-Con Racing "Nothing fancy, just 347 inches of RAT POISON!" MICE need not apply..... 
|
|
|
|
|
09-16-2005, 12:56 AM
|
#3 |
|
87prjctpony
Join Date: Aug 2005
Location: seaside ca
Posts: 57
|
Re: Front Suspension Sqeeks???
so theres no way it needs to be greesed up??
__________________
i have a 87 5.0 gt with mac shorty headers, off-road h-pipe, mac mufflers, transgo shift kit, msd blaster coil, and 3.73 gears. o yeah aod tranny. |
|
|
|
|
09-16-2005, 09:26 AM
|
#4 |
|
Registered Member
Join Date: May 2002
Location: Tampa,FLORIDA
Posts: 340
|
Re: Front Suspension Sqeeks???
I just put new tie rod ends on my car and there was a hole in the bottom where the grease fitting screws in. It came with new grease fittings, but they were not screwed on yet. Maybe yours were never put in?
__________________
5.0, Holley heads, 1.7 Scorp Rockers, Stealth intake, Holley 600 carb, Holley Mech. Fuel pump, MSD 6Digital, MSD distributor, Hotchkis upper/lower rear control arms, FMS B Springs, 3:73 (8.8) rear. Production # 9,377 |
|
|
|
|
09-20-2005, 12:49 AM
|
#5 |
|
87prjctpony
Join Date: Aug 2005
Location: seaside ca
Posts: 57
|
Re: Front Suspension Sqeeks???
Well I'll Need To Find A Way To Make That Noise Stop Because Its Getting Annoyingggg!!!!
__________________
i have a 87 5.0 gt with mac shorty headers, off-road h-pipe, mac mufflers, transgo shift kit, msd blaster coil, and 3.73 gears. o yeah aod tranny. |
|
|
|
|
09-20-2005, 11:15 AM
|
#6 |
|
Registered Member
Join Date: Feb 2001
Posts: 84
|
Re: Front Suspension Sqeeks???
anyone know if the bushings are polyeurathane or rubber on Fox bodies?
__________________
1990 LX 5.0 Cobra Intake K&N filter ET 15.0 Yokohama ES 100. Cobra R 17's DynoMax SS's Pro 5.0 More to come |
|
|
|
|
09-21-2005, 07:17 AM
|
#7 |
|
Rat Killer
Join Date: Aug 2002
Location: Cold ass Ohio
Posts: 1,143
|
Re: Front Suspension Sqeeks???
They're rubber, but Pro-thane makes urethane replacements.
__________________
d-Con Racing "Nothing fancy, just 347 inches of RAT POISON!" MICE need not apply.....
|
|
|
|
 |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 66 mustang front suspension | broncos7307 | Classic Mustangs | 2 | 08-20-2004 12:48 PM |
| front suspension upgrades | hobgoblin351 | Classic Mustangs | 2 | 02-26-2004 12:34 PM |
| front suspension rebuild | wgungho | Corner Carvers Delight | 1 | 02-21-2002 01:36 PM |
| Mustang suspension | Skankin | Corner Carvers Delight | 1 | 08-17-2001 05:10 PM |
| 65 Front End Suspension. | red | Classic Mustangs | 3 | 04-04-1999 11:38 AM |