Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|||||||
|
|
Thread Tools | Rate Thread | Display Modes |
08-02-2001, 12:00 AM
|
#1 |
|
Registered Member
Join Date: Feb 2001
Location: Berkshire County - Massachusetts
Posts: 735
|
How can you tell if Fel-Pro gaskts were installed incorrectly? (hard ?)
I have a 69 351 that was stroked and blueprinted built by a local engine builder and I think he screwed up the install. of the head gaskets. My symptoms are a) It's brand new engine and when I park it on the hill front end down, rear end up, it pushes white smoke like a bastard for a few seconds at startup. b) I'm having legit cooling problems, and 3)I keep blowing thermostat gaskets. White smoke onstartup means water and oil right?
|
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| tremec hard as hell to shift | rob90gt | Windsor Power | 16 | 03-15-2002 02:33 PM |
| Holley ignition, coil, and distributor installed..car won't start. Any ideas? | chadtn2 | Windsor Power | 5 | 08-13-2001 01:13 AM |
| Replacing convertible top. How hard is it? | Dark_5.0 | Windsor Power | 7 | 06-09-2001 09:01 PM |
| Holy Sh*T, $750 to get a cam installed, just labor. | Shotgun28 | Windsor Power | 8 | 01-17-2001 08:18 PM |