Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
02-04-2001, 11:33 AM
|
#1 |
|
Registered Member
Join Date: Jun 1999
Location: Chicago, IL, USA
Posts: 286
|
Grinding Intake for TB install
I am going to install a FMS 65mm Throttle body and I know i will have to grind the opening to the intake for a good fit. How much do i take off. can i just use the gasket and grind it to the edges?
------------------ Red 1993 Gt- flowmasters,BBK Shortie Headers, BBK Hi-Flow H-Pipe, BBK cold air induction w/K&N, Pro 5.0 shifer, 130 amp alt., underdrives,pioneer cd player and kicker component speakers, Kenwood Excelon amp, 2 12" subs in the hatch,firehawk sz50 all around, timing bumped to 13 deg., ADS Superchip, and mobil 1 oil lubing the 302. |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Edelbrock RPM intake install problems | jruppert | Windsor Power | 4 | 03-04-2004 05:05 PM |
| Trick Flow intake problems | shacar87 | Windsor Power | 9 | 11-14-2003 05:53 PM |
| Cobra Intake? | 95mustanggt | Windsor Power | 5 | 10-01-2002 09:55 AM |
| upper intake and egr spacer install..... | scale | Windsor Power | 3 | 08-18-2002 11:37 PM |
| new coolant leak after intake install | fiveohpatrol | Windsor Power | 15 | 03-04-2001 09:15 PM |