
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
#1 |
|
Registered Member
Join Date: Jun 2000
Location: Tonawanda,NY
Posts: 71
|
i've played w.idle adj. plate and screw on tb, tps, egr hooked,unhooked(though not func.)
guy at speed shop said pull chip out, I did it helped alot this whole time idle being the only prob, at 1100, at 1700, or surging from 1000-1800. car drives good, bucks like typical E303 below 2000 on decel(ie. 4gear,30mph,3.73), somehow pulls hard to 6000, falls off a lil but pulls pretty good to 6500 it almost seems as if its retarded, but I've been running a stock cam for the last 2 years(in THIS car)so... is this as worse as it gets(ie. get x303w/1.7's or bigger and live w/surge?) oh yeah, its E303 w/1.7's straight up, heavily ported,milled 289 heads, longtubes 1 5/8, 3"exhaust, performer intake-ported up,lowercleaned up, 70mmtb,elect fan, etc.etc. ------------------ ram air 70mm tb ported performer ported 289heads 1.94,1.6 1 5/8 LT's |
|
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Tuning a speed density system with mods | Fostang | Windsor Power | 6 | 07-10-2002 11:32 PM |
| Idle problem 88GT Speed Density | chuck88 | Windsor Power | 9 | 07-07-2002 09:16 AM |
| First ticket. Sucks, sucks bad. | zepherman | Blue Oval Lounge | 46 | 12-16-2001 07:24 PM |
| EFI conversion with Speed Density and a 351w? | PSI GUY | Windsor Power | 2 | 12-02-2001 11:13 PM |
| speed density question.. | bobtodd | Blue Oval Lounge | 2 | 04-15-2001 02:03 AM |
