MustangWorks.com - The Ford Mustang Power Source!

Go Back   MustangWorks.com : Ford Forums > Website Community > Stang Stories
Register FAQ Members List Calendar

Notices


Reply
 
Thread Tools Rate Thread Display Modes
Old 07-28-2001, 03:08 PM   #1
lx mike
Undescribable
 
lx mike's Avatar
 
Join Date: Sep 1998
Location: Ft Myers Fla
Posts: 1,539
Post Got My 14's! (long)

i got the 14 second times that i knew my car could run. I just need to work on my driving cause i think that is half of it right there. i had changed a few small things and i think between that and my driving is where it came from. the things i changed was the plugs, had ngk platinum in there and i switched to autolites and i also changed fuel filter, when old one was off and i turned it to drain it black crud came out so was way overdue to be changed. i also added a 76 mm c&l mass air kit, it comes with the m.a.f and the tube to the throttle body. i'm not sure if that help any, but when i make more mods later on it will. my best last time was a 15.122 @ 93.43 here's my 4 time slips
run 1 run 2 run 3 run 4
60' 2.341 2.266 2.196 2.384
330' 6.604 6.389 6.327 6.460
660' 9.926 9.710 9.634 9.787
mph 73.52 73.75 75.33 73.45
1320 15.133 14.901 14.858 15.000
mph 96.10 96.23 95.83 96.09

only question i have is this: i have 3'73's and 225-60-15 tires and at end of run my shift lite i have set at 5100 comes on just before finish line but i figured out that 96 mph should be around 47-4800, does that mean my clutch is slipping??


------------------
93-LX: 5 Speed, Flow's with H-Pipe, 3.73's, C&L 76MM Kit, Sub's and K&N.
14.85 @95.83
lx mike is offline   Reply With Quote
Old 07-29-2001, 12:17 PM   #2
46stang
Registered Member
 
Join Date: May 1999
Location: moorpark ca
Posts: 340
Post

congrats on cracking into the 14's. once you get some more practice (60fts) you'll be consistantly in the 14's! I don't think your clutch is slipping, I you would notice it more when you take off from a start than at the end of the track and looking at your 60fts you weren't having a problem burning rubber your tach may be off a little, or sometimes the math just doesn't quite coinside with real life. keep having fun!

------------------
96 stang,ported 99 heads, 99 intake, 99 cams,Steeda power pullies,Kirban adj.reg.,Pro-m 87,24#inj.,70mm t/b,BBK longtube headers,Bassani x-pipe w/cats, Dynomax ultraflow catback,iat mod, home depot ram air, k@n,
373's,cobra brakes,fms spings, lakewood 90/10's and 50/50's tri-ax shifter.
best et 13.80
best mph 103.3
bfg street tires,bakersfield, ca

46stang is offline   Reply With Quote
Old 07-29-2001, 01:41 PM   #3
87vert351
Registered Member
 
Join Date: Jul 2001
Location: Sterling Heights, MI
Posts: 43
Post

Once you get a good launch technique figured out and get the 60' times in the 2.0's you should see low 14's. I wouldn't worry about the end rpm not matching the calculated figures enless you feel the clutch slipping.

------------------
351w, tremec trans Best N/A Pass 11.44@120 Best Nitrous Pass 10.73@128@Norwalk....9th in True Street
87vert351 is offline   Reply With Quote
Old 07-29-2001, 03:34 PM   #4
lx mike
Undescribable
 
lx mike's Avatar
 
Join Date: Sep 1998
Location: Ft Myers Fla
Posts: 1,539
Post

i'm working on how i leave the line now, before i was just letting clutch out real quick and then getting into it,but this time i slipped it a bit more.

------------------
93-LX: 5 Speed, Flow's with H-Pipe, 3.73's, C&L 76MM Kit, Sub's and K&N.
14.85 @95.83
lx mike is offline   Reply With Quote
Old 07-30-2001, 11:22 AM   #5
EZRIDN
Registered Member
 
Join Date: Jan 1999
Location: U.S.A.
Posts: 504
Post

What track....i go to moroso

------------------
'86 GT.
Gears & Flows
14.0 @ 97

'87 GT.
Stock.....over 200K
14.6 @ 95

EZRIDN is offline   Reply With Quote
Old 07-30-2001, 08:10 PM   #6
lx mike
Undescribable
 
lx mike's Avatar
 
Join Date: Sep 1998
Location: Ft Myers Fla
Posts: 1,539
Post

EZ: Bradenton, I live in ft myers about 2 hours south from there and about 3 from moroso.
lx mike is offline   Reply With Quote
Old 07-31-2001, 06:49 PM   #7
Nitrous Al
Registered Member
 
Nitrous Al's Avatar
 
Join Date: May 2000
Location: Everett, MA
Posts: 417
Thumbs up

A little more practice and you'll be running low 14's real soon. It took me a while to "learn" how to launch my supercharged GT. If I remember back before I put on the S-trim, rev it up to 3200rpm and slip the clutch. Try not to bog the motor down, but don't overpower the tires. Practice makes perfect. I "always" spin the tires.
Nitrous Al is offline   Reply With Quote
Reply



Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
Long Tubes for AOD Mustvid Windsor Power 4 09-18-2003 09:29 AM
A Crazy Weekend for the books (Long) Mercury Blue Oval Lounge 9 11-05-2002 12:23 AM
Pick up lines! (long) DAN-MAN Blue Oval Lounge 2 08-07-2002 12:38 AM
TFS High Ports and Long Tubes HORSEMEN RACING Windsor Power 3 07-16-2002 12:57 PM
BBK one-piece flange or MAC individual flange long tube headers. Fox Body Windsor Power 10 04-03-2001 04:25 PM


All times are GMT -5. The time now is 08:54 AM.


SEARCH