![SEARCH](http://www.mustangworks.com/images/search.png)
![The Mustang Works](http://www.mustangworks.com/images/mw_footer_logo.gif)
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
![]() |
#1 |
Registered Member
Join Date: Jul 2000
Location: Dallas, Tx 75235
Posts: 1
|
![]() Is there a way to modify, adapt, or replace the steering column for safety reasons? I want to buy a 66 Mustang for my 16 year-old but the steel column worries me.Any suggestions?
|
![]() |
![]() |
![]() |
#2 |
Registered Member
Join Date: Mar 1999
Location: Dallas, TX
Posts: 208
|
![]() I believe your concerns are actually about the long steering input shafts on these (65-67) cars and not the column itself.
Ford changed to a collapsable column in 68, and the biggest change was getting rid of the one piece input shaft on the steering gear. I'm not sure if you can just swap in a 68 steering box and column, or if you have to go with some kind of aftermarket unit. Pick up an issue of "Mustang Monthly" or "Mustangs and Fords" for vendors to contact. I believe the Aug2000 issue of "Mustangs and Fords" has an article on a retrofit tilt steering column. Good luck. Doc. |
![]() |
![]() |
![]() |
#3 |
Registered Member
Join Date: Jun 2000
Location: glendale arizona
Posts: 22
|
![]() repub1 no offense but your biggest concern if you already havent done it is put the steel divider behind the rear seat.. I am a 16 year old mustang driver.. I dont care about the steering colum.. I am more concerned about the exploding tanks.. I hope you already knew this I didnt want to scare you
------------------ 66 mustang 289x.30 over, holley 600 cfm carb,c4 trans,rebuilt engine, 270+ hp |
![]() |
![]() |
![]() |
#4 |
Registered Member
Join Date: Sep 1999
Location: rowlett tx,usa
Posts: 18
|
![]() you can swap in the later model steering column. you will have to have the later model gear box to do it,just did it to my moms car. it was a little bit of work getting the old steering column out but it will work. they changed the design in mid 67
------------------ |
![]() |
![]() |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
70 Mach1 Steering column | ken testa | Classic Mustangs | 0 | 11-11-2003 06:12 PM |
turn signal-maybe the whole harness-calling all electricians? | rwhite65 | Classic Mustangs | 6 | 07-25-2003 08:40 AM |
88 Steering Column | 82stang | Windsor Power | 0 | 05-07-2002 09:44 PM |
68 Steering column | JimW68 | Classic Mustangs | 0 | 10-19-2001 12:56 PM |
Steering Column - Cruise vs non-cruise | richd | Windsor Power | 0 | 09-20-2001 04:26 PM |