gear install problem

John Cummins · 06-10-2001, 06:43 PM

I'm just getting ready to remove the c-clips but this (s) shaped brace won't allow me to get the c-clips out. It doesn't even show up in any manuals. please help.

crewzin · 06-10-2001, 08:02 PM

That spring holds tension against the gears. If I remember correctly you have to take a long bolt out of the carrier and pry the spring out.

95 King GT · 06-10-2001, 08:16 PM

you must loosen the pinion shaft lock bolt, remove it , then push in on the axle flange and remove the c-lock from the inner end of the axleshaft(a magnet is handy for this job)

06-10-2001, 06:43 PM	#1
John Cummins Registered Member Join Date: May 1999 Posts: 231	gear install problem I'm just getting ready to remove the c-clips but this (s) shaped brace won't allow me to get the c-clips out. It doesn't even show up in any manuals. please help.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Please help stutering problem	Just me	Windsor Power	10	10-18-2002 02:37 PM
Trying to figure out what gear I have...	xspeed02	Windsor Power	7	03-31-2001 10:06 AM
what is the going price of gear install?	82 GT	Windsor Power	9	03-08-2001 05:16 PM
billed 5 times to install clutch by Pauls Auto, please read and give opinions (long)	beefcake	Blue Oval Lounge	2	02-23-2001 03:05 PM
3.73 gear install	RUARK	Modular Madness	3	05-30-2000 08:19 PM

06-10-2001, 08:02 PM	#2
crewzin Registered Member Join Date: May 2001 Location: Sour Lake, TX Posts: 211	That spring holds tension against the gears. If I remember correctly you have to take a long bolt out of the carrier and pry the spring out.

06-10-2001, 08:16 PM	#3
95 King GT Registered Member Join Date: Jun 2001 Location: coweta OK USA Posts: 93	you must loosen the pinion shaft lock bolt, remove it , then push in on the axle flange and remove the c-lock from the inner end of the axleshaft(a magnet is handy for this job)