advice on an eaton m-90 on a 5.0

ekinolik · 12-18-2004, 08:40 PM

OK, I just picked up an eaton m-90 for cheap and was looking for a conversion kit to put it on my 5.0 mustang. I could really use some help with where to find one.

speedytang · 12-21-2004, 01:52 AM

You could hand build it, but the M90 was to small when BBK made one for the 5.0 so you would have the same problem.

Ackbar00 · 12-21-2004, 01:14 PM

No one makes a kit anymore. BBK's used to be based of the M-90, but I am not sure what the Snout length was on it. I am pretty sure it was a lot shorter than the M-90's found on T-Birds and GTP's. You could try getting the Kenne Bell Pipework and use it. I have seen people do that with M-112's off of Cobras and Lightinings, but not sure about the M-90's

12-18-2004, 08:40 PM	#1
ekinolik Registered Member Join Date: Dec 2004 Posts: 1	advice on an eaton m-90 on a 5.0 OK, I just picked up an eaton m-90 for cheap and was looking for a conversion kit to put it on my 5.0 mustang. I could really use some help with where to find one.

12-21-2004, 01:52 AM	#2
speedytang Registered Member Join Date: Oct 1999 Location: Marengo, Ohio.USA Posts: 135	Re: advice on an eaton m-90 on a 5.0 You could hand build it, but the M90 was to small when BBK made one for the 5.0 so you would have the same problem.

12-21-2004, 01:14 PM	#3
Ackbar00 Rebel Fleet Commander Join Date: Oct 2001 Location: Huber Heights, OH Posts: 1,003	Re: advice on an eaton m-90 on a 5.0 No one makes a kit anymore. BBK's used to be based of the M-90, but I am not sure what the Snout length was on it. I am pretty sure it was a lot shorter than the M-90's found on T-Birds and GTP's. You could try getting the Kenne Bell Pipework and use it. I have seen people do that with M-112's off of Cobras and Lightinings, but not sure about the M-90's __________________ 1993 Mustang GT, PTK w/ T-64 - My Cardomain Webpage 11.25@123.5 on only 8 psi. 10.84@121 on only 1 headgasket "The Truth is, Your the Weak, and I am the Tyranny of Evil Men!"

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
eibach advice needed	mustardjohn	Small Ponies	6	08-19-2012 08:12 PM
Advice on injectors...PKRWUD I'd like your advice on this one as well	silver_pilate	Windsor Power	3	06-09-2003 08:59 AM
Eaton Posi, Good buy?	zepherman	Windsor Power	0	02-14-2002 04:09 AM
Header advice	mustangLX92	Windsor Power	8	11-09-2001 02:43 AM