MustangWorks.com - The Ford Mustang Power Source!

Go Back   MustangWorks.com : Ford Forums > Mustang & Ford Tech > Windsor Power
Register FAQ Members List Calendar

Notices


Reply
 
Thread Tools Rate Thread Display Modes
Old 01-10-2004, 10:30 AM   #1
Dark_5.0
Registered Member
 
Dark_5.0's Avatar
 
Join Date: Apr 2001
Location: Staging lane
Posts: 4,337
Default Battery relocation. Any bad effects?

I am seriously considering moving my battery to the trunk. I need room under the hood to mount some stuff and it will help with traction.

All of that sounds great. For the people that have done it are there any bad effects I should know about before I go through with it.

Does the battery still charge the same?

Would I need to upgrade the alternator?

Is it harder to start in cold weather cause of the distance the current has to travel?

Is this a good mod for a daily driver/drag race car?

Thanks,
__________________
92' LX-Big brakes, Lots and lots of suspension, GT40X heads, Ported cobra intake, stock cam, Vortech SC trim.
00' Lightning-Stock
88'CRX-13 second ego killer
Dark_5.0 is offline   Reply With Quote
Old 01-10-2004, 12:33 PM   #2
jonnyk
Being stroked is great
 
jonnyk's Avatar
 
Join Date: Oct 1998
Location: Alberta, Canada
Posts: 772
Default

No it won't charge AS good, but it won't be a huge change. If you run a large (1/0 or larger) wire to the starter, there should be no starting problems. The downsides are you'll need a battery box and have to vent it, and install a cutoff switch, to run it at the track. It's a lot of money IMO for very MINIMAL gains.
If you still have a 2G alternator (stock), you should have upgraded to the 3G long ago. I would do that anyways.
__________________
Novi 2000 now spinning off the snout of the 331...

Mods Pics
jonnyk is offline   Reply With Quote
Old 01-10-2004, 01:30 PM   #3
420nitro
Registered Member
 
420nitro's Avatar
 
Join Date: Nov 2003
Location: Rockford
Posts: 596
Default

When I did the battery relocation I was also kind of like "what a waste of money". But afterwards it made a huge difference in traction and cleaned up my engine conpartment. I am all for it now! Do what JONNYK said, and run a good ground to the frame and a body componet in the trunk for the battery as well. Then run a ground strap from the engine block to the frame up front besides the one you have from the factory w/ a 1/0 guage wire as well too.
Good luck
420nitro is offline   Reply With Quote
Old 01-10-2004, 05:00 PM   #4
USMC302
Registered Member
 
USMC302's Avatar
 
Join Date: Apr 2001
Location: Gallatin, Tn
Posts: 1,326
Default

ditto, I have had no problems, but I used 0 guage wire all around including to the cutoff switch. I also had the 130amp alt before the swap too, so I didn't notice any charging probs. Good luck.
__________________
USMC302 is offline   Reply With Quote
Old 01-11-2004, 02:20 AM   #5
red82gt
Sober voice of Reason
 
red82gt's Avatar
 
Join Date: Nov 1998
Location: Kelowna, B.C., Canada
Posts: 1,514
Default

No problem here either. Used 1/0 welding cable from the battery to the solenoid and a 2 guage cable from the alternator to the cutoff switch and a 1/0 ground cable to the frame. I also used a ground strap from the timing cover to the sway bar bracket.

IMO this is a great mod, cleans up the engine compartment and you are moving a 45 lb object from the least desirable place to have weight on the car to the most desireable place to add weight to the car. Even with my stiff suspension it still made a huge difference in the balance of the car. The cost of the parts to do it right does add up though.
__________________
393W: AFR 205's, hydraulic roller, TKO600.
red82gt is offline   Reply With Quote
Old 01-11-2004, 09:06 AM   #6
Ackbar00
Rebel Fleet Commander
 
Ackbar00's Avatar
 
Join Date: Oct 2001
Location: Huber Heights, OH
Posts: 1,003
Default

Make sure you have plenty of Ground. Orginaly, I had it just grounded in the rear. It had trouble holding it charge. So I also ran another cable up to the factory loaction and have not had a problem since. Had it for 4 years this way. Make sure you get a disconnect switch as well. My battery is a Optima Red.
__________________
1993 Mustang GT, PTK w/ T-64 - My Cardomain Webpage

11.25@123.5 on only 8 psi.
10.84@121 on only 1 headgasket



"The Truth is, Your the Weak, and I am the Tyranny of Evil Men!"

Ackbar00 is offline   Reply With Quote
Reply



Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
Battery Relocation - parts question Stang951 Audio, Security, & Electronics 0 07-20-2002 08:18 PM
NHRA Battery relocation rules Stang_ROTY Windsor Power 3 06-25-2002 03:55 PM
Battery Relocation... Bad89stang Windsor Power 1 12-01-2001 12:47 PM
Battery relocation tips 93GT50 Windsor Power 4 11-12-2001 11:14 PM
Battery rear kit relocation Rocket 99GT Windsor Power 5 06-02-2001 02:50 PM


All times are GMT -5. The time now is 09:20 AM.


SEARCH