© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
01-17-2004, 09:30 AM | #1 |
Registered Member
Join Date: May 2002
Location: Tampa,FLORIDA
Posts: 340
|
Manual or Power Steering?
Ok, I am at a crossroads with the steering. I am putting things back together, and I dont want to put my old rack back since it is out now.
Question is should I go for the Flaming river Manual rack kit. ($479 for everything). Otherwise i need a new power rack, tie rod ends, power steer pump, hoses, etc. In other words I want all new since everything is out now. Would like some input from the guys running manual racks. The car IS NOT a daily driver, just a weekend playtoy/carshow deal. Is the manual steering too hard to deal with? should I stay with power? In the end , the cost will be about the same to go either way, but I have to decide now.
__________________
5.0, Holley heads, 1.7 Scorp Rockers, Stealth intake, Holley 600 carb, Holley Mech. Fuel pump, MSD 6Digital, MSD distributor, Hotchkis upper/lower rear control arms, FMS B Springs, 3:73 (8.8) rear. Production # 9,377 |
01-17-2004, 10:32 AM | #2 | |
Registered Member
Join Date: Nov 2003
Location: Rockford
Posts: 596
|
Re: Manual or Power Steering?
Quote:
My vote is to go with the manual rack, and you can even shine up the polished center for those car shows! Good luck & hope this helps. |
|
01-17-2004, 01:47 PM | #3 |
Registered Member
Join Date: Jun 2001
Location: Fort Leonard Wood, MO
Posts: 179
|
I had the flaming river rack on an 88 street car I have since sold. What a pain in the ***** on street tires. I drove the car alot and parking sucked. bad. Probably would be better w/skinnies but then there would be handling issues. If you building a street car, go w/the power set up. I switched it out for the power set up on the 88 (made it easier to sell too).
__________________
93 GT, 5.8 EFI usual bolt ons, 3.55's, subs, hurst, K+N 78 F100 Short bed, 5.8, dual pipes 4 bbl 03 Sable |
01-17-2004, 02:34 PM | #4 | |
Registered Member
Join Date: Nov 2003
Location: Rockford
Posts: 596
|
Quote:
These parts are for hard core people. I would despise my car if I had to drive it everywhere or occationally. Thats why I drive my other vehicles, and leave my Mustang for racing and the occational blast down the street and nothing more! |
|
01-17-2004, 02:52 PM | #5 |
Registered Member
Join Date: May 2002
Location: Tampa,FLORIDA
Posts: 340
|
Well, as far as parking, the only place I would be parking is either at a car show or in the garage, and maybe at the pits at the track. This car WILL NOT be parked next to granny's grocery getter at the local supermaket. I have three other cars for that.
But it will get the occasional sunday drive. I have never driven a stang with manual rack. Dont know anyone that has one. But I like the idea of cleaning up the engine compartment a bit and no power steer oil mess, etc. I guess my question is: is it impossible to drive other than the track for my above stated purposes? As far as selling it, forget that, (had this car since new and too much money into it).
__________________
5.0, Holley heads, 1.7 Scorp Rockers, Stealth intake, Holley 600 carb, Holley Mech. Fuel pump, MSD 6Digital, MSD distributor, Hotchkis upper/lower rear control arms, FMS B Springs, 3:73 (8.8) rear. Production # 9,377 |
01-17-2004, 03:08 PM | #6 | |
Registered Member
Join Date: Nov 2003
Location: Rockford
Posts: 596
|
Quote:
Now driving your car with the p/s belt off is a huge pain. With the manual rack in its place, its almost half the effort in comparison. (or at least with the skinnies on) IMO Lets put it this way,...with the car parked in the garage on the floor, I can turn the wheel with the least amount of resistence!!!! People I have showed that to, quickly got the manual rack with out a second thought!!!!! |
|
01-17-2004, 03:32 PM | #7 |
Registered Member
Join Date: May 2002
Location: Tampa,FLORIDA
Posts: 340
|
Ok thats a good comparison (no pw st belt on). From what I have read here so far, sounds like I will be getting the manual.
easier than getting a new power rack, new pump, hoses, and all the chrome accessories to cover the ps pulley, pump etc. is the steering more precise with the manual? getting rid of the rag joint makes a difference, etc?
__________________
5.0, Holley heads, 1.7 Scorp Rockers, Stealth intake, Holley 600 carb, Holley Mech. Fuel pump, MSD 6Digital, MSD distributor, Hotchkis upper/lower rear control arms, FMS B Springs, 3:73 (8.8) rear. Production # 9,377 |
01-17-2004, 04:03 PM | #8 |
Registered Member
Join Date: Nov 2003
Location: Rockford
Posts: 596
|
yes, steering is more precise.
The only thing is the steering shaft can be a pain at times but no big deal really. (when removing or reinstalling) Alot of room for adjustment though. Good luck |
01-17-2004, 09:43 PM | #9 |
Registered Member
Join Date: Jun 2001
Location: Fort Leonard Wood, MO
Posts: 179
|
For your stated purpose, the river rack would be fine. Mine was more precise w/the river rack but a pain in the rear in day to day traffic. If that's not what you'll be doing, and selling isn't an option, then go w/the river rack.
__________________
93 GT, 5.8 EFI usual bolt ons, 3.55's, subs, hurst, K+N 78 F100 Short bed, 5.8, dual pipes 4 bbl 03 Sable |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Power steering | RDRZ | Classic Mustangs | 0 | 03-02-2004 07:53 PM |
Manual Steering (how tight should it be) | orlowted | Classic Mustangs | 3 | 01-15-2004 11:12 AM |
power steering to manual | m w douglas | Classic Mustangs | 3 | 07-07-2001 09:59 PM |
Power Steering to Manual conversion | rtz | Windsor Power | 14 | 03-09-2001 05:58 PM |
69 Power Steering | Art | Classic Mustangs | 3 | 06-14-1999 09:08 AM |