© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
12-16-2008, 08:24 PM | #1 |
Registered Member
Join Date: Dec 2008
Posts: 1
|
General engine mods
Hi All,
I am a new member and hope that you can guide me in the right direction. I have some questions regarding heads on a 5.0. Currently I have only cold air intake and full exhaust on the car. I just purchased a Professional products intake and 70mm TB. I want to pick up some heads and plan on running some NOS (75-125) till the bottom end goes. Has anyone ran the Tri Star Cylinder Head Inc custom 5.0 heads? If so, what did you think. Also, are there threads that have gone over best mods for the 5.0? Thanks. |
12-17-2008, 11:53 AM | #2 |
Registered Member
Join Date: Feb 1999
Location: Utica, Michigan
Posts: 2,631
|
Re: General engine mods
Heads like AFR, TFS, Edelbrock, etc.. have all performed well. However I am not sure about the latest "knock off" type heads.
I think you might be suprised how much these engines can take. I sprayed 150 through a 200,000 mile 302 for a couple years. It never failed, and only used a little oil.
__________________
1988 Mustang GT stock bottom 302, C4 10.9 @ 128 with 8 psi of Novi 1000 boost!----STOLEN 1989 Mustang notchback Warmed up 306 with a Procharger. |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Stroker Kit/General Engine Suggestions | CJWAZZ | Windsor Power | 1 | 11-16-2008 12:28 PM |
General Lee | mustangII460 | Blue Oval Lounge | 3 | 06-15-2005 11:31 PM |
4 cyl. engine mods... | Mustangdon93 | Small Ponies | 4 | 02-23-2003 12:04 PM |
General 1/4 Guesstimate...after these mods. | Sonics2042 | Windsor Power | 10 | 09-13-2001 06:07 PM |
ENGINE MODS | MY PRIZE | Modular Madness | 3 | 01-08-2001 01:01 PM |