![SEARCH](http://www.mustangworks.com/images/search.png)
![The Mustang Works](http://www.mustangworks.com/images/mw_footer_logo.gif)
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
![]() |
#1 |
Registered Member
Join Date: Jul 2001
Location: Newnan, Georgia
Posts: 3
|
![]() I am about to lower my 1999 mustang. I was going to buy the Eibach pro-kit. I was wondering if this was the best kit to buy and what other options I had. Also, is there anything else i need to do when i lower it? I have heard that lowering it will cause some alignment problems? I would appreciate some help. Thanks
|
![]() |
![]() |
![]() |
#2 |
College Stanger
Join Date: May 1999
Location: Aiken,south carolina, usa
Posts: 1,097
|
![]() Best kit? Probly not. Make sure you get new cambers and new shocks. Or you will have an alignement problem.
__________________
2003 Sonic Blue Cobra |
![]() |
![]() |
![]() |
#3 |
Registered Member
Join Date: Apr 2002
Location: So. Cal
Posts: 5
|
![]() Get Eibach or H&R. You don't NEED new shocks/struts, but lowering your car with stock shocks/struts will definitely wear them out quicker. After you install your springs, wait about 2 weeks for them to settle, then get an alignment. With Eibach, no caster/camber plates needed.
|
![]() |
![]() |
![]() |
#4 |
Registered Member
Join Date: Apr 2002
Location: San Diego, CA
Posts: 2
|
![]() What I did is get the Sprint Springs installed, put in some steeda caster/camber plates and I'm going to get an alignment tomorrow, no complaints here
![]()
__________________
![]() |
![]() |
![]() |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
my friend needs advice!!! ASAP | jimdrechsler | Windsor Power | 3 | 06-16-2004 07:09 AM |
Advice on injectors...PKRWUD I'd like your advice on this one as well | silver_pilate | Windsor Power | 3 | 06-09-2003 08:59 AM |
Lowering my '96 - Springs? | ncbflo | Modular Madness | 1 | 06-30-2001 09:27 AM |
Please - I need advice on piston to valve clearance ASAP | 2FastLX | Windsor Power | 8 | 03-18-2001 03:05 PM |