Silencer Removal

93GTDIN · 02-09-2001, 03:48 PM

Could anyone tell me how to remove the silencer from my 1993 GT AOD? Much appreciated.

-dino

Chevyguy · 02-09-2001, 04:54 PM

It just bolts into the inner fender cavity with some studs and nuts. Just remove the nuts and you can pull it out. Make sure you find all of them, there were 3 - 5 of them I did that so long ago, may have had to remove the air filter to get at the other side. It seals to the back side of the filter housing. No big deal at all

------------------
Frank W
90 5.0 LX coupe Stone stock soon to be daily driver
74 Chevy Laguna Type S-3 305 apart in garage, getting a 454 to put next to it
www.chevellepages.com/folingo

02-09-2001, 05:06 PM

You WILL have to remove the air filter. Depending on how you like to work it may be helpful to disconnect the air intake tube from the mass air meter as well and remove these parts as an assembly. As Chevyguy said, remove the 3 or 4 nuts and the silencer will drop into the bottom inside of your fender. Here's where it can get tricky. You will have to manuever the silencer around until you find the best angle for it to come out. Not hard, just time consuming.

------------------
Greg
91 LX Convertible

dinomite · 02-09-2001, 08:20 PM

Ya, you have to remove the airbox (that has the air filter inside) and then it will just drop down. At that point, grab a flashlight and start playing around, took me a while to actually get it out of the fenderwall....

93GTDIN · 02-10-2001, 02:59 AM

Is it obvious? what does the air silencer look like? What kind of noise change/performance change will I see?

2FastLX · 02-10-2001, 10:31 AM

You won't notice much at all in the way of HP or noise but it does help a little.

It looks somewhat like a funnel. When you get the filter box off you'll see it. Piece of cake.

dinomite · 02-10-2001, 11:41 AM

I remember in last month's MM&FF they removed the silencer and changed from paper to a K&N filter on their project Mark VII and it was good for a tenth in the quarter mile.

Chevyguy · 02-10-2001, 02:54 PM

Yeah, I don't remember a big change untill I put the K&N in either. But even a few free horses are welcome. Throatier sound though. I had forgotten about wiggling it out of the fender, that did take some head scratching, and my 91 only had a few thousand on the clock at the time, so kinda nervous.

------------------
Frank W
90 5.0 LX coupe Stone stock soon to be daily driver
74 Chevy Laguna Type S-3 305 apart in garage, getting a 454 to put next to it
www.chevellepages.com/folingo

93GTDIN · 02-11-2001, 01:12 PM

After about 30 minutes of kicking the asphault and the curb, I realized that the silencer was removed by the previous owner. On the advice given here, I got a K&N hiflow filter, and the car definitely feels stronger. Other than these 2 mods my car is totaly stock. Is there anything i can do for performacne gains that is as easy as changing the filter, or at least not too much more difficult?

02-09-2001, 03:48 PM	#1
93GTDIN Registered Member Join Date: Jan 2001 Location: Live music capital of the world, TX Posts: 324	Silencer Removal Could anyone tell me how to remove the silencer from my 1993 GT AOD? Much appreciated. -dino

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
air silencer removal mod...	pepe_la_pew15	Windsor Power	4	07-09-2004 09:59 PM
Air silencer removal mod..questions	MineralGray02K	Modular Madness	23	08-01-2002 05:09 PM
air silencer removal	82 GT	Windsor Power	5	04-28-2002 08:37 PM
Airbox silencer removal	KG88GT	Windsor Power	1	02-03-2002 05:58 PM
Air Silencer Question	Beach Boy	Small Ponies	0	05-16-2001 01:47 PM

02-09-2001, 04:54 PM	#2
Chevyguy Backyard Mechanic/Chemist Join Date: Feb 2001 Location: Acton MA USA Posts: 435	It just bolts into the inner fender cavity with some studs and nuts. Just remove the nuts and you can pull it out. Make sure you find all of them, there were 3 - 5 of them I did that so long ago, may have had to remove the air filter to get at the other side. It seals to the back side of the filter housing. No big deal at all ------------------ Frank W 90 5.0 LX coupe Stone stock soon to be daily driver 74 Chevy Laguna Type S-3 305 apart in garage, getting a 454 to put next to it www.chevellepages.com/folingo

02-09-2001, 05:06 PM	#3
cleangreenmachine Guest Posts: n/a	You WILL have to remove the air filter. Depending on how you like to work it may be helpful to disconnect the air intake tube from the mass air meter as well and remove these parts as an assembly. As Chevyguy said, remove the 3 or 4 nuts and the silencer will drop into the bottom inside of your fender. Here's where it can get tricky. You will have to manuever the silencer around until you find the best angle for it to come out. Not hard, just time consuming. ------------------ Greg 91 LX Convertible

02-09-2001, 08:20 PM	#4
dinomite The Dude Join Date: Feb 2001 Location: Arlington, VA Posts: 1,262	Ya, you have to remove the airbox (that has the air filter inside) and then it will just drop down. At that point, grab a flashlight and start playing around, took me a while to actually get it out of the fenderwall....

02-10-2001, 02:59 AM	#5
93GTDIN Registered Member Join Date: Jan 2001 Location: Live music capital of the world, TX Posts: 324	Is it obvious? what does the air silencer look like? What kind of noise change/performance change will I see?

02-10-2001, 10:31 AM	#6
2FastLX The Photoshop Guru Join Date: Feb 2001 Location: Mecca, Indiana Posts: 1,419	You won't notice much at all in the way of HP or noise but it does help a little. It looks somewhat like a funnel. When you get the filter box off you'll see it. Piece of cake.

02-10-2001, 11:41 AM	#7
dinomite The Dude Join Date: Feb 2001 Location: Arlington, VA Posts: 1,262	I remember in last month's MM&FF they removed the silencer and changed from paper to a K&N filter on their project Mark VII and it was good for a tenth in the quarter mile.

02-10-2001, 02:54 PM	#8
Chevyguy Backyard Mechanic/Chemist Join Date: Feb 2001 Location: Acton MA USA Posts: 435	Yeah, I don't remember a big change untill I put the K&N in either. But even a few free horses are welcome. Throatier sound though. I had forgotten about wiggling it out of the fender, that did take some head scratching, and my 91 only had a few thousand on the clock at the time, so kinda nervous. ------------------ Frank W 90 5.0 LX coupe Stone stock soon to be daily driver 74 Chevy Laguna Type S-3 305 apart in garage, getting a 454 to put next to it www.chevellepages.com/folingo

02-11-2001, 01:12 PM	#9
93GTDIN Registered Member Join Date: Jan 2001 Location: Live music capital of the world, TX Posts: 324	After about 30 minutes of kicking the asphault and the curb, I realized that the silencer was removed by the previous owner. On the advice given here, I got a K&N hiflow filter, and the car definitely feels stronger. Other than these 2 mods my car is totaly stock. Is there anything i can do for performacne gains that is as easy as changing the filter, or at least not too much more difficult?