© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
01-22-2003, 04:13 PM | #1 |
Registered Member
Join Date: Jan 2003
Posts: 3
|
Bolt sizes for tranny swap
does anybody know the bolt sizes/length for all the components needed for an aod/tremec tranny swap. flywheel, flex plate, bellhousing, etc. just thinking having the right bolts on hand will make the job a little bit easier. thanks, also, i see the aod to t5 conversion, is the tremec 3550 about the same?
Last edited by firststang; 01-22-2003 at 10:18 PM.. |
01-22-2003, 10:15 PM | #2 |
Registered Member
Join Date: Jan 2003
Posts: 3
|
this is for a 93 gt 5.0 thanks
|
01-24-2003, 03:20 PM | #3 |
Registered Member
Join Date: Mar 2000
Location: lincoln, NE
Posts: 80
|
When I switched out my AODE to the Tremec in my 95 the only thing I needed was different flywheel bolts and for some reason, with a Mcloud blow proof bellhousing different tranny to bellhousing bolts. I think Tremec supplies 7/16" bolts but I ended up needing 1/2". Also I had to very carefully open the bolt holes in the mounting ears of the Tremec. I think that I had to trim a piece off the case of the tranny but I dont remember why.
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Problem, Bolt Removal | KrivoK | Classic Mustangs | 2 | 12-19-2003 07:26 AM |
Cobra Engine Swap...Ways to improve my 98 GT... | xtrememach1racer | Modular Madness | 3 | 10-31-2002 11:23 AM |
66 T to 5.0 swap | yenrab | Classic Mustangs | 1 | 03-23-2002 11:12 PM |
Rearend swap | H'YAMULE | Classic Mustangs | 0 | 02-19-2001 09:48 AM |
2.3 turbo swap | frankiebonzz | Small Ponies | 0 | 06-01-2000 07:44 PM |