Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
08-06-2001, 08:52 PM
|
#1 |
|
Registered Member
Join Date: Jan 2001
Location: Clayton, CA USA
Posts: 116
|
Replacing Motor Mounts
I just bought a set of Tri-Y headers for my '68 convertible. I have P/S, so I also got the P/S adapter to lower the power ram.
The headers installed OK, but the power ram hits the headers even with the adapter. I called Sacramento Mustang where I bought the headers and they said it was probably my motor mounts. Does this sound right? Also, my Chilton's doesn't really cover changing the motor mounts. It describes engine removal with pulling the engine with a lift. Is there a good spot to jack the engine up from the bottom? I didn't see any great spots. ------------------ '68 convert, 289, C-4, Edelbrock Performer package, Tri-Y headers, 3.25 rear gears |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Replacing 96 Mustang Turn Signal Bulb? | icetime97 | Modular Madness | 0 | 02-10-2003 01:45 PM |
| Q's about replacing my headliner | zepherman | Windsor Power | 1 | 10-07-2002 08:12 AM |
| When replacing heads/ intake | Kamaro Killer | Windsor Power | 3 | 09-23-2002 04:48 PM |
| I'm replacing heater core, what else since it's apart | macker123 | Windsor Power | 3 | 09-05-2002 12:21 PM |
| Replacing convertible top | madmiamian | Appearance & Detailing | 0 | 04-11-2002 07:46 PM |