© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
03-13-2003, 07:03 AM | #1 |
Registered Member
Join Date: Feb 2002
Location: Birmingham, Al
Posts: 65
|
engine stand
I finally got my engine out and secured on my stand.I bought a new stand rated at 1000 lbs. and it was cheaper than I expected.($49.00)I know many engines have been built on a stand but my question is are there any precautions I should take to insure this thing stays put.I have been wrenching on this thing and it appears to hold well but it sways like crazy.I am curious if these 4 bolts will actually support my 331 replacement (with all the bolt- ons attatched)I bought this stand at a local tool shop called Harbor Freight Tools and I am not sure what brand it is.Are all stands the same are is there one better that I should look for.I am finally getting deep in this project and get ready for many questions as I am learning as I go.I will post some pics of my mess later today.Thanks for any help in advance
__________________
1992 G.T. oxford white |
03-13-2003, 09:17 AM | #2 |
Registered Member
Join Date: Mar 2003
Location: Round Rock, Texas
Posts: 11
|
I have seen 514 long blocks sitting on engine stands rated at 1000 lbs. I'm not saying I would have done it, but it's been done. I feel sure that your 331 will be more than fine on it.
__________________
Mineral gray 02 GT... with a few mods |
03-13-2003, 12:03 PM | #3 |
Registered Member
Join Date: Dec 2002
Location: Columbus, OH
Posts: 100
|
Only motor I seen tip one is a Hemi.
Murdock |
03-13-2003, 06:37 PM | #4 |
Registered Member
Join Date: Feb 2002
Location: Birmingham, Al
Posts: 65
|
I really was not worried about it tipping as much as I am about these 4 little bolts holding.I also was worried as the stand had no actual brand name and I am learning the hard way that you get what you pay for.I bought some 3 inch bolts at auto zone to attatch the motor to stand and I think they are just standard bolts.I am wondering if there are some special ultra strong bolts or something I need.This motor is going to be taken apart by me just to learn the basics so it is really just a spare motor.I may order a quality stand for my 331 replacement.Any ideas if one stand is better than another or am I just worried for nothing?
__________________
1992 G.T. oxford white |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Rare Mustangs....Got One? | 1969Mach1 | Blue Oval Lounge | 22 | 09-25-2010 04:59 AM |
Very bad experience with Engine Dynamics of San Jose CA | JAGraff | Classic Mustangs | 8 | 06-16-2005 11:43 AM |
Bolts for engine to engine stand?? | DemonGT | Windsor Power | 8 | 04-15-2003 10:16 AM |
Very bad experience with Engine Dynamics of San Jose CA | JAGraff | Small Ponies | 0 | 05-12-1999 02:27 AM |
Very bad experience with Engine Dynamics of San Jose CA | JAGraff | Racer's Club House | 0 | 05-12-1999 02:27 AM |