Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
02-28-2004, 10:06 PM
|
#3 |
|
Registered Member
Join Date: Feb 2002
Location: Maryville,TN
Posts: 415
|
I just did a direct swap. I wish I could find a shop to Tune the car but they are all far off ( Atlanta or Nashville ) It sure would help to have a great tune though. Tommorrow after the gaskets set up and I know I have no leaks I will put the beast through it's paces. From what little driving I did do I noticed much improvement. After looking at the head ports and intake ports I don't think you loose much over the 1/8-1/4 inch of miss matched openings. Maybe a little turbulance but that can't be all that bad. My only concern would be a leak from the coolant ports into the intake port on the heads. There is only a small amount of space between the two. I added plenty of gasket material at those points. We'll see what tommorrow brings!
__________________
98 GT / convertable -98 Saleen engine, Saleen appearance pkg. SHM cams,P&P NPI heads, and so much more! |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| installed pa performance alt | GhettoPop | Windsor Power | 1 | 04-11-2004 09:42 PM |
| CAI Installed Whew!?! | mustardjohn | Small Ponies | 0 | 11-08-2003 05:32 PM |
| Had 4.10's installed....car tops out at 99mph??!! | wantapony2001 | Modular Madness | 10 | 08-04-2003 02:31 PM |
| Getting Novi 1000 installed Wed. | Chris_H | Windsor Power | 3 | 12-31-2001 07:22 PM |
| Holley ignition, coil, and distributor installed..car won't start. Any ideas? | chadtn2 | Windsor Power | 5 | 08-13-2001 01:13 AM |