

© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
![]() |
#1 |
Registered Member
Join Date: Sep 2001
Posts: 1
|
![]() Lets say there are 2 stock mustangs with 5 speeds andeqaul drivers, 1 has 3.73 and the other 2.73. How many car lengths will the 3.73 beat the 2.73? From a stop and a roll?
|
![]() |
![]() |
![]() |
#2 |
Registered Member
Join Date: Apr 2001
Location: Staging lane
Posts: 4,337
|
![]() Lower gears dont always make you faster I ran quicker with my 2.73's than with my 3.73's
------------------ 88 mustang gt convertible bored to 306 BBk equal length headers mac cold air fender kit 3.73 FMS gears cowl hood nitto drag radials ford racing clutch flow masters h-pipe 160* thermostat 16 degrees of timing electric fan off 94' t-bird jacobs electronics cap and wires. Edelbrock 1 1/2 inch drop springs. |
![]() |
![]() |
![]() |
#3 |
Registered Member
Join Date: May 1999
Posts: 5,246
|
![]() From a roll the cars should run pretty much the same. A slight advantage to the 3.73 car. From a dead stop, assuming you were able to use the traction, the 3.73 car will beat the 2.73 car all else being equal by a a couple three tenths in the quarter.
|
![]() |
![]() |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
AdjustTiming & 3.73 Gears install | Blue01GT | Modular Madness | 2 | 03-20-2002 02:46 PM |
2001 Cobra 3.73 question | rshap2000 | Modular Madness | 13 | 01-21-2002 08:24 AM |
2001 Cobra 3.73 ? | rshap2000 | Stang Stories | 11 | 01-11-2002 04:54 PM |
3.55 vs 3.73 | xspeed02 | Windsor Power | 1 | 04-10-2001 09:00 PM |
gas on a 3.73 rear | GodStang | Small Ponies | 3 | 07-29-1999 01:01 PM |