Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
02-23-2006, 11:06 PM
|
#1 |
|
Registered Member
Join Date: Nov 2000
Location: Maple Ridge B.C. Canada, The Best Place In The World
Posts: 871
|
pulled codes, please help
just pulled codes and this is what i came up with
32- evp circuit below min voltage of .24 67- neutral safety circuit failure 29- vss code(got the new gear to go in this week) 56- maf above max voltage of 4.5/TOT sensor output greater than self test max value of 4.8v. can you help me fix these??? or tell me what else to check? thanks!
__________________
1984 Bronco II, 36" Michelin Military Tires, 95 EFI 5.0, NP435 Tranny, NP208 Doubler, NP205 Transfer Case, Fill Size Solid Dana 44 Front End, WH Progressive Rate Rock Crawling Coils, Bronco 8.8 Rear, Skyjacker Softride Leafs, 5.13 Gears, Detroit Locker. Final Crawl Ratio Of 175:1 88 GT Best 60ft. 2.181 Best ET 14.350 Best MPH 98.01 ~WRECKED!!!!~ |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Pulled codes - now CEL is on??? | DZEE'S LX | Windsor Power | 5 | 09-26-2005 07:19 AM |
| Pulled Codes, Please Help | BowTie Eater 5 Liter | Windsor Power | 3 | 04-02-2005 11:19 AM |
| Pulled intake and swapped fuel rails now getting codes. | Rebel79 | Windsor Power | 3 | 09-03-2002 12:13 AM |
| pulled codes and could use some advice | Conman | Windsor Power | 9 | 08-17-2002 06:41 PM |
| Pulled codes today... | bobtodd | Windsor Power | 24 | 08-08-2002 07:55 PM |