If you click the link in my sig, you'll be able to see all my goodies
I haven't dynoed my stang yet since I got the new motor in, but I should be putting out about 450RWHP... That's according to the guy that helped me decide what setup I should go with. I think I'll get somewhere between 400-425. He has his own 900HP drag car, so I'm inclined to go with him. I'm thinking smaller number just so I'm not disapointed when I actually dyno her.
Well, now that you bring up the fact your pushing 300 now and plan to go up to 500+, then those heads would of been fine for you. I've never seen a 302 put out 500HP on motor before. My advice is stick with the same brand with the intake and heads. Typically, companys port match their products. This way you know you'll get flow rates and won't run into any restrictions. Check out ARP heads... They are suppose to be just as good as the Edelbrocks
