Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
02-05-2004, 12:54 PM
|
#1 |
|
Registered Member
Join Date: Jan 2003
Location: Palm Bay, FL
Posts: 432
|
Valve covers clearing intake
While the engine is apart, I figure I might as well throw a set of Edelbrock Elite signature valvecovers on it to advertise my heads. My only question is, they're tall valvecovers...will they clear my cobra intake, or do I need to buy a phenolic spacer? Thanks.
__________________
'91 Mustang GT 5.0 AOD Daily Driver Current stats: NEW 302 short block, E-303 cam (@.050, 220/220, .498/.498, 110 degrees), 1.6 roller rockers, Performer RPM heads (aluminum, 1.9/1.6, 60cc chambers), Cobra intake, Granatelli 75mm MAF, Billet AFPR, Equal-Length Shorty Headers, Off-Road X Pipe, Flowmasters, 4.10 POSI 13.73 at 103.8, ~2.2 60' |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Painted valve covers | surfbeast | Modular Madness | 3 | 04-23-2003 08:19 PM |
| 3.8L ticking under the Valve Covers? | nostang forme | Small Ponies | 2 | 01-02-2003 05:08 AM |
| Do they make intake covers for cobras, out on a limb here...plz read | 96_4.6 | Modular Madness | 0 | 11-02-2002 01:35 AM |
| Valve covers | rbatson | Windsor Power | 8 | 06-10-2002 11:56 PM |
| paxton sn93 and tall valve covers | BLWN327 | Windsor Power | 1 | 03-20-2002 11:26 PM |