Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
06-14-2007, 07:38 AM
|
#1 |
|
Registered Member
Join Date: Feb 2003
Location: Washington
Posts: 33
|
Speed Density and Timming?
Car is an 88GT it has a GT40 intake, shorty equal length headers, 1.6 roller rockers, and a B-cam they are the only mods all the rest is stock. Any suggestions on how much timming to start bumping up with. At this point the timming is at 14 spout connector disconnected but realy how much timming do you think it can take before it losses power just looking for the range say 12-16? Thanks for any help.
__________________
New 302 block, Probe forged pistons,Moly rings,I-beam rods,Main girdle,Canton 7Qt pan,B-cam, Edelbrock 6037's ported/decked,Exploder upper/lower ported,#24 inj,190lph fuel pump,70mm tb,73mm maf,MSD dist/coil,6al box,3.73's,Steeda lca's,QA1 k-member,subs,strut tower brace. |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Help me go from MAF to speed density | budgetmaster | Windsor Power | 2 | 01-16-2003 10:48 PM |
| Speed Density | OneBad91 | Windsor Power | 2 | 12-05-2002 01:50 PM |
| 12 second speed density | Yan88gt | Windsor Power | 9 | 09-13-2001 09:13 PM |
| MAF or Speed Density | mustangLX92 | Windsor Power | 2 | 06-26-2001 03:54 PM |
| 86 speed density | kystang86 | Windsor Power | 4 | 01-05-2001 12:18 AM |