Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
02-09-2003, 07:06 PM
|
#15 |
|
Registered Member
Join Date: Jan 2003
Location: Southern Oregon
Posts: 13
|
Finally done!!!
Ok, I finally got that new edelbrock intake and carter carb on my beast! She sounds and feels much better!!! It is not all that I had hoped but it is still a major improvement. I had several problems.....while taking off the old intake, I broke a bolt. apparently someone had been in there before me and jb welded a smaller stud in one of the intake holes, well of course I broke it off and could not get it out. We had to heat up the head and work it out. I am not sure why they did this an not just put in another right size bolt? The threads were just fine so??? Oh well job done!!
Thanks again for all your help. Next up dual exhaust! |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Valve spring retainer clip removal | Hozer 88GTConv | Windsor Power | 9 | 01-28-2004 11:18 PM |
| valve problem | pearlgt40 306 | Windsor Power | 3 | 07-05-2003 01:21 AM |
| EGR Valve Removal ?? | LOBE_50 | Windsor Power | 1 | 05-07-2002 06:59 PM |
| Proportioning Valve | MidniteWrider | Classic Mustangs | 1 | 07-11-2001 09:14 AM |
| PCV Valve what the ?@#$@#$@$ | Chevyguy | Windsor Power | 3 | 04-11-2001 08:01 PM |