Hybrid Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
05-24-2003, 03:47 AM
|
#1 |
|
Registered Member
Join Date: Apr 2001
Location: Gallatin, Tn
Posts: 1,326
|
I just purchased a 331 kit from The Mustang Depot out of Cali, $996.00 with flat top pistons, racing lightweight rods, bearings, rings, the whole nine yards. The piston are flycut and everything for my TW heads. I will be bringing the block to have it boiled and tested, and have new cam bearings and such installed. But I was pushing close to 350hp with this stock block and it has held up, so with the main girdle and everything, i think it will be fine for the extra 50 or 70 hp I will be trying to sqeeze out of it.
__________________
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| eibach advice needed | mustardjohn | Small Ponies | 6 | 08-19-2012 08:12 PM |
| 66 289 Carb/Head/Intake combo question? | PuPster28 | Classic Mustangs | 18 | 06-12-2003 05:23 PM |
| simple question | Lonzo | Classic Mustangs | 3 | 09-10-2002 09:37 AM |
| Boring question..but need advice | tluv302 | Windsor Power | 3 | 03-06-2002 04:09 PM |
| WELD WHEEL QUESTION on backspacing- your advice | Spenc2u | Windsor Power | 0 | 01-16-2002 03:23 PM |