Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
07-29-2004, 12:18 PM
|
#3 |
|
Registered Member
Join Date: Sep 2002
Location: Boston
Posts: 592
|
Get chrome handles off a cougar. They are the same except in metal. Looks sharp too! Failing that, get your new replacements, flip them over and abserve the terrible design. There are 2 pins that hold the handle to the frame. Get some epoxy and fill in the area around these pins and make sure to keep flexing the handle so you dont epoxy your handles into the closed position. This adds worlds of strength. Then do as suggested above.
Hope this helps!
__________________
91 GT Carb conversion, holley 600 double pumper, edelbrock performer intake, FMS "C" drop springs, march 1000 underdrive pullies, crane 1.7 roller rockers, GT-40P headers, bassani x pipe, american thunder catback, FMS 4.56's, msd aL6, trunkmount battery, A/C eliminator kit, 3000 stall tci streetfighter, AOD with transgo kit, A+ servo, 300M hardened lockup shaft, kevlar bands and 28,000 gvw trans cooler, 3 core radiator, 300 lbs stripped with a full interior |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Another crank broke!!! | 5ohCOUPE | Windsor Power | 8 | 07-12-2004 08:06 PM |
| Looks like I broke it AGAIN!!!!!! | 420nitro | Windsor Power | 10 | 07-01-2004 05:24 PM |
| Car broke down today! | Five0 | Windsor Power | 8 | 03-29-2002 10:40 PM |
| friend broke a control arm on launch! | Coupe5oh | Windsor Power | 3 | 11-14-2001 09:54 PM |
| Well, it finally broke! | Gautam | Blue Oval Lounge | 3 | 07-03-2001 09:32 PM |