

© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
![]() |
#1 |
Registered Member
Join Date: Aug 2000
Location: Miami, Florida
Posts: 116
|
![]() Ok, guys. It's been 2 weeks and about 500 miles later.
My car runs hard, but I know I can get more out of it WITH THE SETUP I HAVE NOW. I have been playing with it and I get good power sometimes and lower power when I play with it more. I need tricks and suggestions of what I can do NOW with the setup I have. I know you will advice me to update some parts but right now I cant. What more can I do with my current setup to get the MAX POWER out of it What do I set the fuel pressure to? TPS? Timing....I LIKE TOTAL WITH CHIP OUT REMEMBER: I like to know what I can do with the setup I have now. I can NOT change anything now like injectors and MAss air, but soon will. But on MOTOR, WHAT tunning, Fuel Pressure, Total timing ETC should I put it at. And any tricks and suggestions are welcome. Below is what I have now running on the car. 302 block Rebuilt Fresh bearings Fresh rings Cobra Upper GT 40 Lower Ported TFS Track Heats (out of the box) Crane Cams 2040 Reground By Crawford Performance 1.6 Scorpion Roller Rokers FMR 65mm TB BBk Equal Lenth Shorty Headers Billit Fuel Pressure Regulator Under Drive Pullies Moroso Cold Air MSD Blaster TFI Coil X-Pipe with 2 chamber Flowmaster Cobra water pump pully 34 Degree Total Timing with spout out Short Belt Taylor 8.8 Blue Wires 3.8 Taurus Electric Fan 3.08 Gears (soon 3.55's) 19# Injectors (soon 24lb) Stock mass air __________________
__________________
89 Mustang Police Interceptor Cobra Upper Intake GT-40 Lower Intake Ported TFS Track Heats Heads Crane Cams 2040 Reground By Crawford Performance 1.6 Scorpion Roller Rokers FMR 65mm TB BBk Equal Lenth Shorty Headers Billit Fuel Pressure Regulator (45Lbs) Under Drive Pullies Moroso Cold Air MSD Blaster TFI Coil X-Pipe with 2 chamber Flowmaster Cobra water pump pully 34 Degree Total Timing with spout out Short Belt No Air Silencer Hurst Short Throw Shifter Taylor 8.8 Blue Wires 3.8 Taurus Electric Fan 3.08 Gears (soon 3.55's) 19# Injectors (soon 24lb) Stock mass air |
![]() |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
good setup? | spankaveli | Windsor Power | 5 | 11-11-2002 11:29 PM |
Should I Run a Carb or EFI Setup? Please Help | BlackFireN2O | Windsor Power | 1 | 08-07-2002 03:16 PM |
drag setup?? 86GT-struts,? | 429mustang | Windsor Power | 2 | 06-20-2002 01:56 PM |
speed density setup, could this work? has anyone tried? | mikos chris | Windsor Power | 2 | 10-13-2001 02:20 AM |
Pics of my setup | 84_GT350 | Windsor Power | 3 | 08-18-2001 02:43 PM |