Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
06-30-2005, 12:43 PM
|
#1 |
|
Registered Member
Join Date: Mar 2000
Location: Berwick,Pa
Posts: 127
|
cross threaded, yikes!!!!
while installing my ported e7's e-cam and edelbrock performer rpm intake i cross threaded the hole in the top of the lower intake for the metal heater tube. i think i only got the top couple threads i tried to run it after i saw what i did but it leaks like a sieve. is there a way to sleeve it or how would i go about trying to retap it. any advice would be appreciated being that i don't have 500 bucks to replace it and the the stock one isn't an option either. thanks
jason 89 GT efi |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| block to cross member lenght issues. | ols0051 | Windsor Power | 0 | 06-14-2005 10:47 AM |
| Cross your fingers for me!!! Just applied to SMU | RedLilPony | Blue Oval Lounge | 6 | 01-22-2003 08:59 PM |
| Josh reaches a cross roads. What to do? | tireburner163 | Blue Oval Lounge | 19 | 04-16-2002 06:04 PM |
| More answers to. "Why did the chicken cross the road?" | tireburner163 | Blue Oval Lounge | 3 | 01-02-2002 01:34 AM |
| Cross Drilled Rotors - Who uses them? | 2FastLX | Windsor Power | 6 | 09-29-2001 12:05 AM |