You should have two wires in one lead, and four in the other, coming from the module. The two wire lead will have a red wire and a white wire. The four wire lead should have one each of these colors: green, orange, purple and black. Connect them as follows:
White: To the Start terminal on the ignition switch.
Red: To the Run terminal on the ignition switch.
Green: To the Negative side of the coil.
Orange: To the Orange lead from the Stator Assembly in the distributor.
Purple: To the Purple lead from the Stator Assembly in the distributor.
Black: To the distributor ground.
The last three should be in a 3 wire harness coming from the distributor.
Take care,
-Chris
|