Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
05-15-2002, 08:58 AM
|
#2 |
|
Junior Member
Join Date: Mar 1999
Location: Ventura, California
Posts: 8,981
|
You should have two wires in one lead, and four in the other, coming from the module. The two wire lead will have a red wire and a white wire. The four wire lead should have one each of these colors: green, orange, purple and black. Connect them as follows:
White: To the Start terminal on the ignition switch. Red: To the Run terminal on the ignition switch. Green: To the Negative side of the coil. Orange: To the Orange lead from the Stator Assembly in the distributor. Purple: To the Purple lead from the Stator Assembly in the distributor. Black: To the distributor ground. The last three should be in a 3 wire harness coming from the distributor. Take care, -Chris
__________________
Webmaster: Rice Haters Club Jim Porter Racing Peckerwoods Pit Stop Support Your Local
RED & WHITE! |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 5.0 swap and wiring | surfsup | Windsor Power | 1 | 10-04-2004 11:24 AM |
| follow up to horrible vibration problem | Toeclicker | Windsor Power | 4 | 12-18-2003 06:38 PM |
| Please help stutering problem | Just me | Windsor Power | 10 | 10-18-2002 02:37 PM |
| Speedo/Tach Wiring Problem | gofishing | Classic Mustangs | 0 | 07-01-2002 09:48 AM |
| need help with wiring problem | 8d850 | Windsor Power | 2 | 06-14-2002 09:24 AM |