I realize that 7/16 is the way to go, but i am trying to do as little fabrication work as possible to the top end. The pedestal r.r.'s on this engine are motorsports 1.6:1. These have quite a few miles on them from the last engine. Instead of just replacing these with new pedestal r.r.'s i would rather have the adjustability of the stud mounted r.r. Will the 5/16 stud conversion kit accept a rocker stud girdle? And will all this clear my motorsports valve covers(it's the valve cover thats wrinkle black and has "Powered by Ford" on the top)?
thanks again..in advance
dave
|