hmm
Well something aint right then. You said that the fit is really tight around the throttle body but i don't see how that is possible. The part of the inlet pipe that goes to the thottle body is 76mm around or across or whatever. The throttle body is only 65mm. That leaves 11mm of extra space from the inlet tube to the throttle body. Right now i put the tube w/ the rubber connector over the throttle body and wiggle it around quite a bit. This really stinks cuz i wanted to put it on tomorow and now it won't fit.... Some one please help!
__________________
'89 LX 5.0, off-road h pipe, flowmaster muffs, underdrive pulleys, rebuilt WC T-5, King Cobra Clutch, 65mm throttle body, Explorer Upper/GT40 lower, Lakewood Rear Lift Bars. 76mm C&L Mass air w/ inlet pipe, Twisted wedge heads w/ stage 2 port,polish, MAC equal length shorties, Billet AFPR, 255LPH fuel pump, fresh low end w/ 10.5:1 compression.
If anyone ever wants to go to Raceway Park in Englishtown New Jersey, give me a shout.
RICER HATERS CLUB MEMBER 87!
www.ricehatersclub.com
|