I am having the same problem right now, I just installed a dual friction.
I did not add any extra grease to the bearing retainer or throwout bearing as suggested by the throwout bearing manufacter since it comes pre-greased. I should have done so and probably replaced the crappy aluminum retainer with a steel one. I am going to try and grease it with the tranny in the car. I will post my sucess or failure (probably the latter).
__________________
-1993 Mustang, 900rwhp 03-04 cobra based 4v swap, full Griggs setup, project underway
-1994 Ranger w/ 427cid windsor (daily beater)
check it out!
|