Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
08-28-2002, 02:40 PM
|
#2 |
|
Registered Member
Join Date: Aug 2001
Location: Huntington NY
Posts: 573
|
I am having the same problem right now, I just installed a dual friction.
I did not add any extra grease to the bearing retainer or throwout bearing as suggested by the throwout bearing manufacter since it comes pre-greased. I should have done so and probably replaced the crappy aluminum retainer with a steel one. I am going to try and grease it with the tranny in the car. I will post my sucess or failure (probably the latter).
__________________
-1993 Mustang, 900rwhp 03-04 cobra based 4v swap, full Griggs setup, project underway -1994 Ranger w/ 427cid windsor (daily beater) check it out! |
|
|
|
|