MustangWorks.com : Ford Forums - View Single Post - What the f%^$!! Is it possible for the vac. tree to blow fluid into the plenum????

K.C. 5.0 · 07-31-2001, 01:57 PM

I'd check your vac. line connections and make sure they are attached good. I had to use clamps on mine after installing my new intake. If you had a leak on the drivers side rail, when the rail is under pressure it will spit out fuel bad. At lest mine did. But if your vac. wasn't on good and tight it could have sucked in the fuel that was spraying out of your rail. Just something to check. Might not be your problem.

------------------
95gt 80k, MSD 6AL, MSD coil, pulleys, fpr, cold air kit, off road h-pipe, flowmasters, 3.73, 9mm wires, mega bite jr lowers, kennybrown subframe connectors, edelbrock performer intake, 70mm TB, 73mm C&L, 24lb injectors Aluminum Driveshaft, Tri-Ax shifter.

07-31-2001, 01:57 PM	#6
K.C. 5.0 Registered Member Join Date: Jun 2001 Location: KC,Mo,US Posts: 70	I'd check your vac. line connections and make sure they are attached good. I had to use clamps on mine after installing my new intake. If you had a leak on the drivers side rail, when the rail is under pressure it will spit out fuel bad. At lest mine did. But if your vac. wasn't on good and tight it could have sucked in the fuel that was spraying out of your rail. Just something to check. Might not be your problem. ------------------ 95gt 80k, MSD 6AL, MSD coil, pulleys, fpr, cold air kit, off road h-pipe, flowmasters, 3.73, 9mm wires, mega bite jr lowers, kennybrown subframe connectors, edelbrock performer intake, 70mm TB, 73mm C&L, 24lb injectors Aluminum Driveshaft, Tri-Ax shifter.