MustangWorks.com : Ford Forums - View Single Post

surfbeast · 11-24-2003, 11:36 AM

I've got the P.I. cams ready to go in. With the cost of the used cams ( $75 ) and the cost of gaskets etc.. and maybe the labor I'm looking at the 250 - 300 range for total cost. Way better than a T/B and spacer. Take duces advice and don't waste money on non performance junk. Your list of mods is a good start and now you are basically left with spending big bucks to get any more HP out of your pony. The cams are probably the lowest cost bang for your buck right now!

11-24-2003, 11:36 AM	#6
surfbeast Registered Member Join Date: Feb 2002 Location: Maryville,TN Posts: 415	I've got the P.I. cams ready to go in. With the cost of the used cams ( $75 ) and the cost of gaskets etc.. and maybe the labor I'm looking at the 250 - 300 range for total cost. Way better than a T/B and spacer. Take duces advice and don't waste money on non performance junk. Your list of mods is a good start and now you are basically left with spending big bucks to get any more HP out of your pony. The cams are probably the lowest cost bang for your buck right now! __________________ 98 GT / convertable -98 Saleen engine, Saleen appearance pkg. SHM cams,P&P NPI heads, and so much more!