Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
11-24-2003, 11:36 AM
|
#6 |
|
Registered Member
Join Date: Feb 2002
Location: Maryville,TN
Posts: 415
|
I've got the P.I. cams ready to go in. With the cost of the used cams ( $75 ) and the cost of gaskets etc.. and maybe the labor I'm looking at the 250 - 300 range for total cost. Way better than a T/B and spacer. Take duces advice and don't waste money on non performance junk. Your list of mods is a good start and now you are basically left with spending big bucks to get any more HP out of your pony. The cams are probably the lowest cost bang for your buck right now!
__________________
98 GT / convertable -98 Saleen engine, Saleen appearance pkg. SHM cams,P&P NPI heads, and so much more! |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| white face guages look like crap at nite | blk88lx | Windsor Power | 12 | 04-04-2004 11:35 PM |
| crank shaft spacers | BilLster | Windsor Power | 0 | 04-24-2003 02:53 PM |
| 2 Q's - Wheel spacers and Off road pipe | SteveK | Modular Madness | 5 | 02-22-2002 10:41 AM |
| Wifes car running like crap need HELP | LX90Stang | Windsor Power | 5 | 08-21-2001 05:27 PM |
| plenum spacers?? | DemonGT | Windsor Power | 2 | 04-27-2001 12:05 PM |