The "dash" sizes are used in all types of hydraulic hose/fitting/tubing, like AN, JIC, SAE, pipe thread, etc.
Now, can anyone tell me what degree the taper is on the nose or seat of the fitting? I'm not sure if AN is the same as JIC which is 37 degrees or SAE which is 45 degrees. The threads are the same for both.
------------------
91 coupe
3.73's,long tubes,2 1/2" exh,ported stock t-body,ProM-77mm
cobra intake,edelbrock heads,B303,1.72 rr's
36lb inj's,tremec, & a Paxton NOVI 2000!!!
11.020 @128.95 on BFG Drag Radials (275/60/15)
[This message has been edited by SisuStang (edited 01-24-2001).]
|