

© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
![]() |
#7 |
Guest
Posts: n/a
|
![]() The "dash" sizes are used in all types of hydraulic hose/fitting/tubing, like AN, JIC, SAE, pipe thread, etc.
Now, can anyone tell me what degree the taper is on the nose or seat of the fitting? I'm not sure if AN is the same as JIC which is 37 degrees or SAE which is 45 degrees. The threads are the same for both. ------------------ 91 coupe 3.73's,long tubes,2 1/2" exh,ported stock t-body,ProM-77mm cobra intake,edelbrock heads,B303,1.72 rr's 36lb inj's,tremec, & a Paxton NOVI 2000!!! 11.020 @128.95 on BFG Drag Radials (275/60/15) [This message has been edited by SisuStang (edited 01-24-2001).] |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Grease Question | Kisner | Classic Mustangs | 9 | 03-16-2004 07:47 PM |
creaking noise!! AHH! | 89GTimporteater | Windsor Power | 4 | 03-20-2003 06:49 PM |
What fittings will i need? | mustangLX92 | Windsor Power | 0 | 07-02-2002 07:33 AM |
Teflon tape with nitrous fittings | Radon | Windsor Power | 4 | 04-05-2002 01:04 AM |
Oil Leak from S-Trim fittings...HELP | quick89gt | Windsor Power | 0 | 08-03-2001 03:44 PM |