DO NOT even atempt to install the gears yourself unless you have the proper tools and technical knowledge to set proper pinion depth and correct gear mesh for both drive surfaces on the gears.
If you have vibrations in the driveline, the gears were not set up correctly or the driveshaft is out of balance and installed in a different position then it was removed.
I can go over proper rear end setup if anyone would like that. I have done many drag race and also some hybrid 8.8/9 inch road race rear ends.
__________________
-1993 Mustang, 900rwhp 03-04 cobra based 4v swap, full Griggs setup, project underway
-1994 Ranger w/ 427cid windsor (daily beater)
check it out!
|