Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
05-23-2004, 10:15 PM
|
#12 |
|
Registered Member
Join Date: Aug 2001
Location: Huntington NY
Posts: 573
|
DO NOT even atempt to install the gears yourself unless you have the proper tools and technical knowledge to set proper pinion depth and correct gear mesh for both drive surfaces on the gears.
If you have vibrations in the driveline, the gears were not set up correctly or the driveshaft is out of balance and installed in a different position then it was removed. I can go over proper rear end setup if anyone would like that. I have done many drag race and also some hybrid 8.8/9 inch road race rear ends.
__________________
-1993 Mustang, 900rwhp 03-04 cobra based 4v swap, full Griggs setup, project underway -1994 Ranger w/ 427cid windsor (daily beater) check it out! |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Suspension ?--Bullitt, Eibach, Stock, or COMBO??? | rel3rd | Windsor Power | 3 | 10-15-2002 07:53 PM |
| stock gears? | greengoblin | Modular Madness | 2 | 07-15-2002 02:16 PM |
| Stock No More | Stroked408 | Windsor Power | 9 | 06-12-2002 08:19 PM |
| Pro-M on stock motor? | NotchJohnson | Windsor Power | 3 | 03-23-2002 10:28 PM |
| slicks who's runnin them on a stock rear | 302crew | Windsor Power | 8 | 09-14-2001 06:30 PM |