I am getting my block machined right now. The place i am getting it done at is charging $125 for bore and hone, and like $40 for clean up. Then, there is all these other little charges, like changing the bearings and what not. I cant remember how it is for me to get my block decked. My heads will cost about (starting, depending on how much they take off) $30 each i think, to get them plained. All together its like $450 for the machining, plus switching out the pistons and installing them and the crank. (to figure out how much it needs to be decked) I am also getting a entire rebuild kit from them, with a higher performance cam. Everything will be about $770 for me.
|