Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
09-28-2004, 11:16 PM
|
#7 |
|
Registered Member
Join Date: Mar 2004
Location: Minnesota
Posts: 950
|
I am getting my block machined right now. The place i am getting it done at is charging $125 for bore and hone, and like $40 for clean up. Then, there is all these other little charges, like changing the bearings and what not. I cant remember how it is for me to get my block decked. My heads will cost about (starting, depending on how much they take off) $30 each i think, to get them plained. All together its like $450 for the machining, plus switching out the pistons and installing them and the crank. (to figure out how much it needs to be decked) I am also getting a entire rebuild kit from them, with a higher performance cam. Everything will be about $770 for me.
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| block and head machining questions | bmxmon | Windsor Power | 6 | 09-26-2004 02:21 PM |
| 65 - 66 Restoration Costs | Bossco | Classic Mustangs | 4 | 04-24-2003 04:29 AM |
| extra gear costs | Stang39r | Windsor Power | 3 | 03-31-2002 08:00 PM |
| Where can I find engine block machining specs? | 2FastLX | Windsor Power | 0 | 11-30-2001 01:34 AM |
| Machining on a stock throttle body - can it be done?? | 2FastLX | Windsor Power | 5 | 03-29-2001 10:34 AM |