Well I mocked up a PP this last week relocating the 76mm C&L to the bottom, it didn't like that so I changed the design to keep it up towards the stock location. I used PVC to mock it up and I am just going to buy some mandrel bent tubing. I have found the tubing from any Diesel Truck shop, and a buddy of mine bought some from JC Whitney, I have a link to the Diesel Shop, I'll post it tomorrow from work. If I can make it there is no way I am going to spend $190 on one from AFM.
I heard on another board you can buy the C&L tube like the one that comes on the 76mm for $40 but I do not know for sure. Tiny advenger also sells one, they advertise in the back on the MM&FF and 5.0 I think.
------------------
Check Out My Site 91GT,Holley SysteMAX II Kit-Heads 2.02" x 1.60" port matched to a 1262,Anderson N-61,24#,76mm C&L,Full MAC, No A/C or PS or emissions, 12" K&N Filter,RNH PERFORMANCE Ram Air,Ron Davis Radiator,Full Suspension, SPEC stage III clutch, Lakewood SFI bell, S&W 8pt "X" brace,JAZ seats,3:73's,Welds..etc,4:30's and 31 splines coming very soon!
[b]12.16 @ 113.5, 1.78 60ft..no traction in the 90 degree