PKRWUD where would i attach the vacuum gauge hose to. What should the Vacuum read at first 15 ???????
Timing? Where should the White out Line be when when the light hits it? I marked it at 10 and when the light hits it the mark is in between the metal piece. It reads
time ------->
|
|
| the line ends up between here
|
|
|
(O)End of the metal piece
2fastlx => If i pulled out the Crossover how would i be able to tell if they're clogged b/c i have two on each side! If it is the cats im not sure if WA has the strict emissions if not!! Im goin to thow in a X pipe w/ o cats
Unit 5302 => I doubt it would be anything electrical such as the MAF Injectors and so on b/c they ran perfectly before and i run codes about once a week to see if any thing is wrong and i dont get any. So The cats are the one thing the computer wont pick up on and what could have been the problem all along!
------------------
1992 Mustang 5.0
BBK cold air intake
Dual Flows w/ H Pipe
BBK Underdrive Pulleys
BBK 65mm Throttle Body
[This message has been edited by caliplaya650 (edited 09-21-2001).]