Cant Wont Go Past 2500 RPM part: II **LONG**

caliplaya650 · 09-21-2001, 12:45 PM

PKRWUD where would i attach the vacuum gauge hose to. What should the Vacuum read at first 15 ???????

Timing? Where should the White out Line be when when the light hits it? I marked it at 10 and when the light hits it the mark is in between the metal piece. It reads
time ------->
|
|
| the line ends up between here
|
|
|
(O)End of the metal piece

2fastlx => If i pulled out the Crossover how would i be able to tell if they're clogged b/c i have two on each side! If it is the cats im not sure if WA has the strict emissions if not!! Im goin to thow in a X pipe w/ o cats

Unit 5302 => I doubt it would be anything electrical such as the MAF Injectors and so on b/c they ran perfectly before and i run codes about once a week to see if any thing is wrong and i dont get any. So The cats are the one thing the computer wont pick up on and what could have been the problem all along!

------------------
1992 Mustang 5.0
BBK cold air intake
Dual Flows w/ H Pipe
BBK Underdrive Pulleys
BBK 65mm Throttle Body

[This message has been edited by caliplaya650 (edited 09-21-2001).]

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
GM Engines	BLOCKER	Blue Oval Lounge	2	04-13-2004 12:35 AM
87-93 GT 3rd Brakelight: Bulb part #	ponyboy25	Windsor Power	5	04-13-2003 08:48 PM
Speed Secret # 3	jim_howard_pdx	Windsor Power	13	11-09-2002 10:35 AM
Experience with Edelbrock RPM Package	jim_howard_pdx	Windsor Power	0	10-27-2002 01:10 AM
8,000 RPM!!!! A few questions about race motors	vetteeatr	Windsor Power	10	06-16-2002 01:18 PM

09-21-2001, 12:45 PM	#6
caliplaya650 Registered Member Join Date: Jul 2001 Location: Moses Lake, Wa USA Posts: 72	PKRWUD where would i attach the vacuum gauge hose to. What should the Vacuum read at first 15 ??????? Timing? Where should the White out Line be when when the light hits it? I marked it at 10 and when the light hits it the mark is in between the metal piece. It reads time -------> \| \| \| the line ends up between here \| \| \| (O)End of the metal piece 2fastlx => If i pulled out the Crossover how would i be able to tell if they're clogged b/c i have two on each side! If it is the cats im not sure if WA has the strict emissions if not!! Im goin to thow in a X pipe w/ o cats Unit 5302 => I doubt it would be anything electrical such as the MAF Injectors and so on b/c they ran perfectly before and i run codes about once a week to see if any thing is wrong and i dont get any. So The cats are the one thing the computer wont pick up on and what could have been the problem all along! ------------------ 1992 Mustang 5.0 BBK cold air intake Dual Flows w/ H Pipe BBK Underdrive Pulleys BBK 65mm Throttle Body [This message has been edited by caliplaya650 (edited 09-21-2001).]