View Single Post
Old 03-01-2006, 08:07 AM   #6
bigwhitecobra
Huh? Whatcha said?
 
bigwhitecobra's Avatar
 
Join Date: Oct 2000
Location: Fayetteville, NC
Posts: 1,073
Default Re: Help: 2001 Cobra Dying out after engine rebuild.

Sounds to me like you have a small, but serious vacuum leak. Go over all the hoses, and make absolutely sure that all are connected. Check your vacuum lines and such. The problem is not related to plugs, or even your rebuild.

As far as break in goes, there are several opinions about it, but the fact is, if it runs......your good. Jump on her a few times and see if she holds together. If she has ran above 3K, she will run up to 7K.

Hope some of this helps. And for the record, I always break my vehicles in as per instructions, but common sense tells me that if it holds together on for the initial start up and warm up, she'll hold together for almost anything.
__________________
2003 GT White---STOLEN
May you burn in hell whoever took it. Dumbazz didn't even get the good engine that was in the garage.
bigwhitecobra is offline   Reply With Quote