Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
03-01-2006, 08:07 AM
|
#6 |
|
Huh? Whatcha said?
Join Date: Oct 2000
Location: Fayetteville, NC
Posts: 1,073
|
Re: Help: 2001 Cobra Dying out after engine rebuild.
Sounds to me like you have a small, but serious vacuum leak. Go over all the hoses, and make absolutely sure that all are connected. Check your vacuum lines and such. The problem is not related to plugs, or even your rebuild.
As far as break in goes, there are several opinions about it, but the fact is, if it runs......your good. Jump on her a few times and see if she holds together. If she has ran above 3K, she will run up to 7K. Hope some of this helps. And for the record, I always break my vehicles in as per instructions, but common sense tells me that if it holds together on for the initial start up and warm up, she'll hold together for almost anything.
__________________
2003 GT White---STOLEN May you burn in hell whoever took it. Dumbazz didn't even get the good engine that was in the garage. |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| What do I need to Rebuild my engine? | Silver5.0 | Windsor Power | 0 | 10-07-2001 05:44 PM |
| Is the 4.6 Cobra engine found in any other Ford Product | Joel F | Small Ponies | 1 | 08-10-2001 04:58 PM |
| 66 Engine Rebuild | mustangbob19 | Classic Mustangs | 2 | 07-16-2001 06:05 PM |
| Rode in a brand new 2001 Cobra....1st time in a cobra | 84stangLX | Stang Stories | 4 | 05-02-2001 10:39 AM |
| Engine rebuild | Mike5p0 | Windsor Power | 11 | 01-25-2001 01:24 PM |