I have the MAC kit and it looks really good but I had to modify it to fit with my strut tower brace( cut about 1inch off the end where ir connects to the TB).I also took out the elbow that goes down in the fender because I think it was messin with my Mass Air(stock)makin my rpms at idle low and fluctuate.I'll try it again when I get a new Mass air, but it still looks good in there.Hope this helps a little.
------------------
1999 GT AOD,FMS 70MM TB,Steeda pullies,Dynomax Super Turbos,MAC cold air kit,Steeda strut tower brace,ATS-III seq. turn signals
|